Installation Process
Section 3 Installation
Installation Process
The following is needed:
•
A Torx TX7 screwdriver
1.
Unpack and check the delivery. If damage is found, notify the supplier.
2.
Place the operator panel on a stable surface during installation. Dropping the
operator panel or letting it fall may cause damage.
3.
To cut a correct opening for the operator panel, use the cut out
dimensions in the outline drawing. For more information, see sections
and
4.
Secure the operator panel in position by screwing the M4 Torx screw, allowing
the built-in bracket to tighten against the panel:
M4 x 20.7
0.4 Nm
Figure 1. A. M4 x 20.7, 0.4 Nm
18
3BSE069462-600 Rev D
Summary of Contents for PP882
