Wireless collar / key
chain sensor
(Ref. 8131)
ENG –
User Manual
abb
1.- Technical data
Battery:
CR2032
Note:
The sensor is delivered with a new battery inserted into the product.
Please, remove the transparent strip to start working.
Battery service life:
approx. 5 years.
RF channels:
1 wireless sensor (transmitter) channel. Switch ON type.
Radio frequency:
868 MHz
Range:
Approx. 30m inside buildings. 100m free field space conditions.
Operation temperature:
0 - 45ºC.
2.- Configuration
2.1.- Wireless key chain sensor view
Red LED
Push button
Selector switch:
Programming mode
Operation mode
2.2.- Link configuration
1.
Set the wireless switch actuator (receiver), which we would like to link
to the wireless key chain sensor, in programming mode.
2.
At the wireless key chain sensor: (a) move the selector switch to
“programming mode” position and (b) press the push button.
3.
If the link process is successful and the RF key chain has correctly
learned the actuator linked, LED at the wireless key chain sensor
lights continuous red for 3 seconds.
If programming fails during link process, the LED at wireless key
chain sensor briefly flashes three times, indicating it has not learned
any actuator. Please, repeat the sequence from point 1.
Note:
To assure the wireless key chain sensor is well working with the actuator,
the link configuration process should be successfully done. The LED at the
wireless key chain sensor should light continuous red for 3 seconds at the end of
the linking process.
3.- Operation
Important:
In operation mode, the selector switch of the LED at the wireless
key chain sensor should be at “operation mode” position.
Help warning operation
Every time the RF key chain is pressed, it will start a sequence of sending ON
actuation telegrams to the actuator linked.
-
If the actuator (receiver) confirms the wireless key chain sensor the
reception of the ON telegram sent by the the wireless key chain sensor, it
will stop sending ON telegrams and it will lights for 3 seconds the red LED.
-
If the actuator (Receiver) does not confirm the wireless key chain sensor
the reception of the telegram sent by the wireless key chain sensor, it will
repeat sending the ON telegram every 10s during 5 minutes, until it
receives the acknowledgement of reception from the actuator linked. Every
telegram is sent, red LED will shortly flash once.
When battery is low and RF key chain is pressed, red LED light flashes briefly 3
times each time an ON RF telegram is sent. Please, change battery as soon as
possible.
Note:
When wireless key chain has not been linked with any actuator (receiver)
wireless device and its push button is pressed, it does not send any telegram and
it will not light the red LED, indicating this way, it is not properly working. It should
be linked with a wireless actuator for properly working.
4.- Battery replacement
1.
To access the battery, remove the screw of the housing.
2. Remove battery from the battery holder helped by an
screwdriver
3.
Insert a new battery
Important:
Observe the polarity, positive and negative poles of the battery,
when inserting it into the holder. Product is damaged if battery is inserted
reversed. See picture above.
5. Guarantee
This product is subject to the guarantee offered in the selling general terms of
ABB in each country.
