Nexus®Pro GATEWAY
Tel: (888) 552-6467 Fax: (800) 316-4515
03/24 750.2095 Rev. B
3/4
© 2024 ABB. All rights reserved.
Installing the Gateway to a DIN Rail
1. Ensure power is off.
2. Hook lower latch of DIN rail adapter mounting clip to lower edge of the DIN rail as shown in figure 4.
3. Lift Gateway up onto DIN rail and snap into top of the DIN rail adapter mounting clip as shown in figure 4. The upper latch of the DIN
rail adapter mounting clip will lock onto the DIN rail when released.
Removing the Gateway from a DIN Rail
1. Ensure power is off.
2. Pull up on the Gateway to release the upper latch of the DIN rail adapter mounting clip.
3. Tilt the upper part out to un-latch and lower the Gateway off the DIN rail.
Supplying Power and Turning ON the Product
1. Using the supplied power adapter, plug the connector into the “Power in” connector on the bottom of the Gateway.
2. Plug the adapter into a standard wall receptacle.
Cleaning the Product
1. Use water-based, non-flammable, cleaning products to remove dirt.
2. Use a dry, lint-free, cloth to remove dust.
3. Never use detergents, aerosol sprays, solvents or abrasive sponges.
DIN rail
mounting clip
Gateway
Figure 4: Gateway installation
(Antennas not shown for clarity)
DIN rail adapter
WI-FI / B
LUETO
OTH
®
WI-FI 5
GHz
WI-FI
/ BLU
ETOO
TH
®
WI-FI
5GHz
DIN rail
Gateway
Figure 5: Gateway removal
(Antennas not shown for clarity)
mounting clip
DIN rail adapter
WI-FI
/ BLU
ETOO
TH
®
WI-FI 5
GHz
WI-FI
/ BLU
ETOO
TH
®
WI-FI
5GHz
Figure 6: Supplying power
ETH1
POWER IN
12-24 VDC
NOMINAL
POWER IN
12-24 VDC
NOMINAL
Ref.#
Description
1
Ethernet ETH 1 connector
2
Power IN connector
1
2
L' li
t ti
él t i