ABB JSM D28 Installation Manual Download Page 5

Page: 5 / 5

INSTALLATION GUIDE

REV. B

5/5

Install the handle profile on the door and

fasten with screws (A). Make sure the profile
placement is aligned with Magne.

10.

Insert the cover profile (P).

11.

Install the two remaining self-tapping screws

(O) 3.5 x 13 mm (x2) to fixate the cover plate and
to finalize the installation.

12.

Check the function by opening and closing

the door several times.

Complete product range and accessories are found at

Summary of Contents for JSM D28

Page 2: ...and orientation of Eva sensor Depending on how Magne is installed on the fence Eva and the anchor plate can be installed in two ways Ensure that Eva is installed and oriented in the holes to which the corresponding Magne model is installed See figures below for alternative ways of installation and orientation of Eva ...

Page 4: ... x4 for the anchor plate 7 Pre assemble the handle profile H using suitable length of M6 screw A washer R centering plate B and special nut C 8 Install end cap N x2 on both sides of the profile using self tapping screws O 3 5 x 13 x6 Note End cap with opening for cabling can be installed on any profile end The fourth screw is installed later see step 11 ...

Page 5: ...ent is aligned with Magne 10 Insert the cover profile P 11 Install the two remaining self tapping screws O 3 5 x 13 mm x2 to fixate the cover plate and to finalize the installation 12 Check the function by opening and closing the door several times Complete product range and accessories are found at www abb com jokabsafety ...