ABB i-bus KNX FCL/S 1.6.1.1, Product Manual

Page: 49 / 104

ABB i-bus
®
KNX
Start-up
FCL/S x.6.1.1 | 2CDC508116D0203 47
3.2.2.3.1 Parameter window - Status messages (One-level)
This is the parameter window where status messages are defined.
This parameter window is always visible for output A. For outputs C, D and E it is visible if the Outputs C,
D, E parameter in Parameter window Enable outputs A...F on p.20 is set to Enable as fans .
Enable communication object
"Status Byte mode" 1 byte
Options: No
Yes
This status byte indicates the states Control value selection, Automatic, Forced operation and the four limi-
tations via a 1 bit coding.
For further information see: Fan status byte, forced/operation , p.98

Yes : The communication object Status Byte mode is enabled and the following parameter appears:
Send object values
Options: No, update only
Only after changing
After request
After a change or request

No, update only : The status is updated but not sent.

Only after changing : The status is sent after a change.

After request : The status is sent after a request.

After a change or request : The status is sent after a change or a request.