ABB i-bus KNX FCL/S 1.6.1.1, Product Manual

Page: 19 / 104

ABB i-bus
®
KNX
Start-up
FCL/S x.6.1.1 | 2CDC508116D0203 17
3.2 Parameters
ETS Engineering Tool Software is used for parameterizing the device.
In ETS, the application appears in the Catalogs window under Manufacturers/ABB/Heating , Ventilation, Air
conditioning/Ventilation actuator.
The following chapter describes the parameters of the device using the parameter windows. Parameter
windows are structured dynamically so that further parameters may be enabled depending on the parame-
terization and function of the outputs.
The default values of the parameters are underlined, e.g.:
Options: Yes
No
Note
The FCL/S 1.6.1.1 outputs are:
A: Fan output
B: Switch actuator output
The FCL/S 2.6.1.1 outputs are:
A: Fan output
B: Switch actuator output
C, D, E: One fan output or parameterizable as switch actuators
F: Switch actuator output
Note
All parameter window descriptions and control options refer to the FCL/S 2.6.1.1 2-fold Blower Actuator.
The application for the FCL/S 1.6.1.1 1-fold Blower Actuator has no
Enable outputs A…F
parameter
window, i.e. output A is always a fan output and the additional switch output B is always activated.