Operation Manual / TPL65-A32 / -A33 / -A36 + TPL69-A32 / -A33
8 Disassembly and assembly / 8.8 Dismantling and fitting nozzle ring
at turbine end
© Copyright 2018 . All rights reserved.
HZTL2498_EN
Revision C
April 2018
8.8 Dismantling and fitting nozzle ring at turbine
end
NOTICE
If only the nozzle ring has to be removed, this can be done at the tur-
bine end.
Removing nozzle ring
u
Remove insulation from gas inlet casing (51001).
u
Loop rope around gas inlet casing and secure with lifting gear.
CAUTION
When looping the securing line around the casing, make sure that no
cleaning pipes are squashed or damaged. Do not fasten the lifting gear
to cleaning pipes under any circumstances.
u
Remove two hexagon-head screws (61044) together with Verbus
Ripp® washers (61043) from the bottom section and replace them
with two studs (90177).
u
To secure, screw hexagon nuts (90178) onto studs (90177).
Page
93
/
118
