ABB FOX615, Installation & User Manual

Page: 74 / 98

I N S T A L L A T I O N P R O C E D U R E S
72 FOX615

Installation
Figure 46: Alignment of the heat deflection shield R7AI for evacuation
of heated air to the front
3.8.2 Installing the shield
Heat deflection shield R7AI
installation
Proceed as follows:
1. Turn the shield for heat evacuation to the rear or front (refer to Figure 45
or Figure 46 ) whichever is appropriate for your installation.
2. Locate the fixing position of the shield in the 19-inch rack or within the
ETSI adapters above the FAMO1 or FAMO1-F (option) or above the
FOX615 subrack (refer to
Figure 6 and Figure 15 respectively).
3. Lift the shield into position and secure the shield with four M6 screws.
4. Tighten the M6 screws provisionally.
End of instruction
Please note:
For efficient heat evacuation of the heat produced below the FOX equipment
the installation of a heat evacuation shield (proper orientation) below the
cable tray is recommended (refer also to
Figure 4 ).
cold air
heated air