ABB FOX615, Installation & User Manual

Page: 45 / 98

I N S T A L L A T I O N P R O C E D U R E S
FOX615

Installation 43
3.4.2 Installing the DC power supply
3.4.2.1 Power cable
The power cable (refer to Figure 23 ) connects the external power circuit(s) to
the FOX local power interface(s). One end of the power cable is terminated
with the TYCO connector for the FOX subrack (or DUPF1). The other end is
terminated with the WAGO connector block. This connector block provides
the connection point for the external power supply.
Power cables are required as follows:
•
Single power source supply:
1 power supply cable is required
• Dual power source supply:
2 power supply cables are required.
Please note:
The second power cable is delivered together with the DUPF1 in a separate
package.
Figure 23: FOX power supply cable
Legend:
1 WAGO connector block
2 TYCO connector
The WAGO connector block is mounted on the cable tray either inside the
• right
OR left side panel of the cable tray for single power source sup-
plies.
• right AND left side panels of the cable tray for dual power source sup-
plies.
Figure 24 shows the 2 installation options.
blue
Blue (-)
Blue (-) Red (+)
Red (+)
1
2
A
A
red