ABB FlexPLP IRPLP 220, Product Manual

Page: 11 / 146

How to read the product manual
Reading the procedures
The procedures contain references to figures, tools, material and so on. The
references are read as described below.
References to figures
The procedures often include references to components or attachment points
located on the device/controller. The components or attachment points are marked
with italic text in the procedures and completed with a reference to the figure where
the current component or attachment point is shown.
The denomination in the procedure for the component or attachment point
corresponds to the denomination in the referenced figure.
The table below shows an example of a reference to a figure from a step in a
procedure.
Note Action
Shown in the figure Location of
gearbox
on page 120 .
Remove the rear attachment screws, gearbox. 8
Reference to required equipment
The procedures often include references to equipment (spare parts, tools, and so
on.) required for the different actions in the procedure. The equipment is marked
with italic text in the procedures and completed with a reference to the section
where the equipment is listed with further information, i.e. article number, dimension.
The denomination in the procedure for the component or attachment point
corresponds to the denomination in the referenced list.
The table below shows an example of a reference to a list of required equipment,
from a step in a procedure.
Note Action
Art. no. is specified in Required
equipment on page 57 .
Fit a new sealing, 2 to the gearbox. 3
Safety information
The manual includes a separate safety chapter that must be read through before
proceeding with any service or installation procedures. All procedures also include
specific safety information when dangerous steps are to be performed.
For more information, see Safety on page 13 .
Product manual - FlexPLP IRPLP 220 11
3HAW050041018-001 Revision: C
© Copyright 2016 - 2018 ABB. All rights reserved.
How to read the product manual