PUSH
UP
Release Bar
Released
(Open)
NOTICE:
If tool does not operate properly, do no attempt repair or adjustment. Call nearest ABB Installation Products Inc. sales office to arrange
for repair service. Any change, modification or alteration of the tool or use by the customer in a manner other than as specified by ABB Installation
Products Inc. shall void all warranties express or implied and the customer shall, therefore, assume all liability for any damage or injury caused by
said changed, modified or altered tool or improper usage of such tool.
IN ORDER TO OBTAIN WARRANTY SERVICE YOU MUST REGISTER YOUR
PRODUCT BY LOGGING IN ON
tnb.abb.com/toolregistration.
FAILURE TO
REGISTER YOUR PRODUCT VOIDS ALL WARRANTIES.
ABB Installation Products Inc.
8 Bvd du Millenium,
Memphis, Tennessee
B-7110 La Louvière,
tnb.abb.com
Belgium USA
© 2019 ABB Installation Products Inc. All Rights Reserved.
For parts, service, repair and
calibration, contact the ABB Installation Products Inc.
Tool Service Center at 1-800-284-TOOL (8665).
To release the SHURE STAKE
®
mechanism, push up on the
release bar until the ratchet
teeth are disengaged.
1. Remove dust, moisture, and other contaminants with a clean brush or a soft, lint-free cloth.
2. DO NOT use on objects that could damage the tool.
3. Make certain all pins, pivot points, and bearing surfaces are protected with a THIN coat of any good SAE No. 20 motor oil.
DO NOT oil excessively.
4. Keep handles closed when not in use to prevent objects from becoming lodged in the crimping dies.
5. Store tool in a cool, dry area.
TA05264 B Page 2 of 2
WARNING
KEEP ALL BODY PARTS AWAY
FROM DIE NEST DURING GAGING
OR CRIMPING PROCEDURE.
SHURE STAKE
®
Mechanism
Figure 3
1.2
Maintenance
1.3
Comfort Crimp and Shure Stake are registered trademarks of
ABB Installation Products Inc. in the United States and/or other countries.