2TLC172272M0201
Rev E
17
Mounting
Depending on the cable connector used for the connection to Eden, one or two distance plates
might be required for correct mounting in order to avoid damaging Adam. It is recommended to
use the distance plates (DA 1B) supplied with the Adam models with M12 connector (Adam M12),
see figure below. Also, the mounting spacers supplied must be used in order to physically protect
Eden from damage.
The cable should be mounted so that no force is applied on Adam in any directions. The cable
should be fixed if it is connected to a moving object, for example a cable chain or a door. This can
be done with for example two cable clamps.
Caution!
An improperly installed cable can damage the sensor.
Mounting with one distance plate (DA 1B) for
Adam M12 using prewired moulded M12 connector
Mounting with two distance plates (DA 1B) for
Adam M12 using M12 connector with glanded
cable.
Incorrect mounting without distance plate may
cause permanent damage to the sensor
.
Accepted