Commissioning and service field (ISF)
30
EBS852, EBS862 (Contrac) 42/68-831-EN
7.1.4 Defining the initial position (0% or 100%)
2.
Use a travel button (9) to move to the desired position.
3.
Press the Accept button (2) or (4) to accept the position; if successful, the corresponding
LED will flash at a rate of 1 Hz. The other LED will continue to flash at approx. 4 Hz.
7.1.5 Defining the second position (0% or 100%)
4.
Use a button (9) to move to the second position.
5.
To accept the position, press the Accept button (2) or (4). If successful, both LEDs(5) and
(10) will flash at a rate of approx. 1 Hz.
7.1.6 Saving your settings
6.
Press both Accept buttons (2 + 4) to accept the settings. The LEDs (5 + 10) will stop flashing
after a short period of time to indicate that the setup process is complete.
7.
If the range selected for the actuator is too small, both LEDs will start to flash again at 4 Hz
and the setup procedure will have to be repeated with a higher value (min. actuator travel).
(Information regarding actuator travel appears on the name plate.)
