Chapter 6 - Exchange of Thyristors for Size A6
DCS 500 / DCS 600 Service Manual
VI A
6 - 7
Install new thyristor
1. Ensure that the new thyristor is of the correct type (
). Keep the semiconductor and its surroundings clean. If
necessary clean them with a piece of tissue paper moistened
with solvent.
Note
: Do not touch the polished surfaces of the thyristor.
2. Clean the polished surfaces of the semiconductor with a piece
of tissue paper moistened with solvent. Dry all surfaces. Spread
a
thin
layer of heat conducting paste on both sides of the thyris-
tor, if necessary use a rubber spatula.
Figure 6-7
Prepare disk type thyristor
3. Clean all parts with tissue paper moistened with solvent, witch
have had or will have contact with the thyristor or each other
(lower / upper heat sink). Do not clean the surfaces of grease
too thoroughly, because the aluminum surfaces will oxidize in a
few seconds. Dry all surfaces.
4. Centre the thyristors by means of the spring pins.
Note
: Be sure that the thyristor is installed in the right direction.
Do not pinch or cut the gate leads or any other cable.
5. Turn the thyristor so that the gate leads point in the right direc-
tion. When changing BCT’s make sure, that gate B is in front
(
6. Connect the gate leads if possible.
7. Insert first the top DC-busbar plate and then the bottom one.
3ADW000093R0701_DCS500B/DCS600_Service manual_e_g
