C1300
Advanced circular chart recorder
3 Configuration
22
IM/C1300 Rev. J
Totalizers Display
Note.
Displayed only if the totalizer software option is enabled by installation of the appropriate
software key.
Select the style of totalizer display required in the
Operating Page
– see Sections 2.3.6 to 2.3.10.
Off
– totalizer values are not displayed in the
Operating Page
Separate
– totalizer values for totalizers assigned to channels 1 and 2 are
shown separately on display screen 1. Totalizer values for totalizers
assigned to channels 3 and 4 (3 and 4 pen recorders only) are
shown separately on display screen 2 – see Section 2.3.6, page 13
Rate with Total
– totalizer values for totalizers assigned to channels 1 and 2, together
with the current measured values for channels 1 and 2, are shown
separately on display screen 1. Totalizer values for totalizers
assigned to channels 3 and 4 (3 and 4 pen recorders only),
together with the current measured values for channels 3 and 4,
are shown separately on display screen 2 – see Section 2.3.7, page
13
Total with Rate
– the current measured values for channels 1 and 2, together with
totalizer values for totalizers assigned to channels 1 and 2, are
shown separately on display screen 1. The current measured
values for channels 3 and 4 (3 and 4 pen recorders only), together
with totalizer values for totalizers assigned to channels 3 and 4, are
shown separately on display screen 2 – see Section 2.3.8, page 14
Dual Total
– totalizer values for totalizers assigned to channels 1 and 2 are
shown simultaneously on display screen 1. Totalizer values for
totalizers assigned to channels 3 and 4 (3 and 4 pen recorders only)
are shown simultaneously on display screen 2 – see Section 2.3.9,
page 14
Dual + Flow Rate
– totalizer values for totalizers assigned to channels 1 and 2, together
with the current measured values for channels 1 and 2, are shown
simultaneously on display screen 1. Totalizer values for totalizers
assigned to channels 3 and 4 (3 and 4 pen recorders only),
together with the current measured values for channels 3 and 4,
are shown simultaneously on display screen 2 – see Section
2.3.10, page 15
Note.
Do not select
Dual + Flow Rate
if a totalizer is not assigned to each of the channels to
be displayed – see Section 3.7, page 35.
Other Channels Display
Select
YES
to display information for input channels not assigned to pens.
Alarm Adjust
Select
YES
to enable alarm set point adjustment in the
Operating Page
Continued on next page.
Totals Display
Separate
Other Ch Display
NO
Alarm Adjust
NO
Totalizer Reset
NO
