ABB ACSM1 Series, Manual

Page: 91 / 510

Parameters and firmware blocks
91
Group 01 ACTUAL VALUES
This group contains basic actual signals for monitoring the drive.
01
Firmware block:
ACTUAL VALUES
(1)
1.01 SPEED ACT FW block: SPEED FEEDBACK (page 149 )
Filtered actual speed in rpm. Used speed feedback is defined by parameter 22.01 SPEED FB SEL .
Filter time constant can be adjusted by parameter 22.02 SPEED ACT FTIME .
1.02 SPEED ACT PERC FW block: ACTUAL VALUES (see above)
Actual speed in percent of the motor synchronous speed.
1.03 FREQUENCY FW block: ACTUAL VALUES (see above)
Estimated drive output frequency in Hz.
1.04 CURRENT FW block: ACTUAL VALUES (see above)
Measured motor current in A.
1.05 CURRENT PERC FW block: ACTUAL VALUES (see above)
Motor current in percent of the nominal motor current.
1.06 TORQUE FW block: ACTUAL VALUES (see above)
Motor torque in percent of the motor nominal torque.
1.07 DC-VOLTAGE FW block: ACTUAL VALUES (see above)
Measured intermediate circuit voltage in V.
1.08 ENCODER 1 SPEED FW block: ENCODER (page 256 )
Encoder 1 speed in rpm.
1.09 ENCODER 1 POS FW block: ENCODER (page 256 )
Actual position of encoder 1 within one revolution.
ACTUAL VALUES
14
MISC_3 2 m sec (1)
1.02 SPEED ACT PERC
1.03 FREQUENCY
1.04 CURRENT
1.05 CURRENT PERC
1.06 TORQUE
1.07 DC-VOLTAGE
1.14 SPEED ESTIMATED
1.15 TEMP INVERTER
1.16 TEMP BC
1.20 BRAKE RES LOAD
1.22 INVERTER POWER
1.26 ON TIME COUNTER
1.27 RUN TIME COUNTER
1.28 FAN ON-TIME
1.31 MECH TIME CONST
1.38 TEMP INT BOARD