ABB ACSM1 Series, Manual

Page: 209 / 510

Parameters and firmware blocks
209
Group 51 FBA SETTINGS
Further fieldbus communication configuration. These parameters need to be set only
if a fieldbus adapter module is installed. See also
Appendix A – Fieldbus control on
page 423 .
Notes:
• This parameter group is presented in the User’s Manual of the fieldbus adapter as
parameter group 1 or A.
• The new settings will take effect when the drive is powered up the next time
(before powering off the drive, wait at least 1 minute), or when parameter 51.27
FBA PAR REFRESH is activated.
51
51.01 FBA TYPE FW block: None
Displays the fieldbus protocol on the basis of the adapter module installed.
Not defined Fieldbus adapter module not found (not properly connected, or
disabled by parameter
50.01 FBA ENABLE ).
(Fieldbus protocol) Fieldbus adapter for the stated protocol installed.
51.02 FBA PAR2 FW block: None
… …. ….
51.26 FBA PAR26 FW block: None
Parameters 51.02…51.26 are adapter module-specific. For more information, see the User’s Manual
of the fieldbus adapter module. Note that not all of these parameters are necessarily used.
51.27 FBA PAR REFRESH FW block: None
Validates any changed adapter module configuration parameter settings. After refreshing, the value
reverts automatically to
(0) DONE .
Note: This parameter cannot be changed while the drive is running.
(0) DONE Refreshing done.
(1) REFRESH Refreshing.
51.28 PAR TABLE VER FW block: None
Displays the parameter table revision of the fieldbus adapter module mapping file stored in the
memory of the drive.
In format xyz, where x = major revision number; y = minor revision number; z = correction number.
51.29 DRIVE TYPE CODE FW block: None
Displays the drive type code of the fieldbus adapter module mapping file stored in the memory of the
drive.
Example: 520 = ACSM1 Speed and Torque Control Program.