ABB ACSM1 Series, Firmware Manual

Page: 93 / 334

Parameters and firmware blocks
93
Group 16 SYSTEM
Local control and parameter access settings, restoration of default parameter
values, save of parameters into permanent memory.
16
16 SYSTEM
16.01 LOCAL LOCK FW block: None
Selects the source for disabling local control (Take/Release button on the PC tool, LOC/REM key of
the panel). 1 = Local control disabled. 0 = Local control enabled.
WARNING! Before activating, ensure that the control panel is not needed for stopping the
drive!
Bit pointer: Group, index and bit
16.02 PARAMETER LOCK FW block: None
Selects the state of the parameter lock. The lock prevents parameter changing.
Note: This parameter can only be adjusted after the correct pass code has been entered at parameter
16.03 PASS CODE.
(0) LOCKED Locked. Parameter values cannot be changed from the control panel.
(1) OPEN The lock is open. Parameter values can be changed.
(2) NOT SAVED The lock is open. Parameter values can be changed, but the changes
will not be stored at power switch off.
16.03 PASS CODE FW block: None
After entering 358 at this parameter, parameter 16.02 PARAMETER LOCK can be adjusted.
The value reverts back to 0 automatically.
16.04 PARAM RESTORE FW block: None
Restores the original settings of the application, i.e. parameter factory default values.
Note: This parameter cannot be changed while the drive is running.
(0) DONE Restoration is completed.
(1) RESTORE DEFS All parameter values are restored to default values, except motor
data, ID run results, and fieldbus, drive-to-drive link and encoder
configuration data.
(2) CLEAR ALL All parameter values are restored to default values, including motor
data, ID run results and fieldbus and encoder configuration data. PC
tool communication is interrupted during the restoration. Drive CPU is
re-booted after the restoration is completed.
16.07 PARAM SAVE FW block: None
Saves the valid parameter values to the permanent memory.
Note: A new parameter value is saved automatically when changed from the PC tool or panel but not
when altered through a fieldbus connection.