Parameters 305
Speed ref ramped
(page
).
11
Speed ref used
).
12
Torq ref used
(page
).
13
Freq ref used
).
14
Process PID out
(page
16
Process PID fbk
(page
17
Process PID act
).
18
Process PID dev
(page
19
Source selection (see
). -
Defines a filtering time for the peak value logger. See
parameter
2.00 s
0.00 … 120.00 s
Peak value logger filtering time.
100 = 1 s
Selects the signal to be monitored by amplitude logger 2. The
signal is sampled at 200 ms intervals, and can be scaled
using parameter
The results are displayed by parameters
…
. Each
parameter represents an amplitude range, and shows what
portion of the samples fall within that range.
Amplitude logger 2 can be reset using parameter
. The logger is also reset whenever the signal source
or scaling is changed. The date and time of the last reset are
stored into parameters
respectively.
Zero
None (amplitude logger 2 disabled).
0
Motor speed used
(page
).
1
Output frequency
).
3
Motor current
(page
4
Motor torque
(page
6
DC voltage
(page
7
Power inu out
(page
8
Speed ref ramp in
(page
).
10
Speed ref ramped
(page
).
11
Speed ref used
).
12
Torq ref used
(page
).
13
Freq ref used
).
14
Process PID out
(page
16
Process PID fbk
(page
17
Process PID act
).
18
Process PID dev
(page
19
Ambient
temperature
).
The amplitude range of 0…100% corresponds to 0…60 °C or
32…140 °F.
20
Source selection (see
). -
Defines the signal value that corresponds to 100% amplitude. 100.00
0.00 … 32767.00
Signal value corresponding to 100%.
1 = 1
No.
Name/Value
Description
Def
/
FbEq16
Summary of Contents for ACS880-x04
