ABB ACS880 Series, Firmware Manual

Page: 529 / 764

Def / Type
FbEq 16b / 32b Description Name / Range /
Selection No.
0 Restart delay enable signal is disabled. Not selected
1 Restart delay enable signal is enabled. Selected
2 Digital input DI1 ( 10.2 DI delayed status , bit 0). DI1
3 Digital input DI2 ( 10.2 DI delayed status , bit 1). DI2
4 Digital input DI3 ( 10.2 DI delayed status , bit 2). DI3
5 Digital input DI4 ( 10.2 DI delayed status , bit 3). DI4
6 Digital input DI5 ( 10.2 DI delayed status , bit 4). DI5
7 Digital input DI6 ( 10.2 DI delayed status , bit 5). DI6
10 Digital input/output DIO1 ( 11.2 DIO delayed status , bit
0).
DIO1
11 Digital input/output DIO2 ( 11.2 DIO delayed status , bit
1).
DIO2
12 Parameter 74.1 ESP control word (page 519) , bit 5 status
controls enable/disable status of the function.
ESP CW bit 5
See Terms and abbreviations (page 169) . Other [bit]
2.0 s / real32 Defines the time period for a drive to keep modulating
at speed defined with parameter
75.52 Kick start speed
reference .
Kick start hold time 75.51
10 = 1 s / 10 = 1 s Kick start hold time. 0.0 ... 30.0 s
4.0% / real32 Defines the speed reference used to perform kick-start
routine. The base value to calculate the kick start speed
reference is parameter
99.9 Motor nominal speed .
Kick start speed
reference 75.52
10 = 1% / 10 = 1% Kick start speed reference. 0.5 ... 100.0%
100.0% / real32 Defines the motor current reference used when the
kick-start routine is active. This current produces higher
starting torque necessary for the motor to overcome
static friction and starting spinning.
The base value to calculate the kick start current
reference is parameter
99.6 Motor nominal current .
Kick start current ref 75.56
10 = 1% / 10 = 1% Kick start current ref. 0.0 ... 300.0%
100.0 %/s / real32 Defines the kick-start reference change rate facilitating
gradual increase of motor current. Kick start current
ramp 75.57
10 = 1 %/s / 10 = 1
%/s Kick start current ramp. 0.0 ... 1000.0 %/s
ESP CW bit 6 / unit32 Defines the source for the current pulse-start enable
signal.
For further information, see section
ESP production
mode.
Note: This feature is applicable only for AC induction
motors.
Current pulse start
mode enable 75.60
0 Restart delay enable signal is disabled. Not selected
1 Restart delay enable signal is enabled. Selected
2 Digital input DI1 ( 10.2 DI delayed status , bit 0). DI1
Parameters 529