ABB ACS880 N5700 Series, Firmware Manual, Page: 385 / 662

Def / Type
FbEq 16b / 32b Description Name / Range /
Selection No.
5 Drive generates an A7C2 FBA B communication warning.
This only occurs if control is expected from the FBA B
interface, or if supervision is forced using parameter
50.56 FBA B comm supervision force .
WARNING!
Make sure that it is safe to continue operation
in case of a communication break.
Warning
0.3 s / uint16 Defines the time delay before the action defined by
parameter
50.32 FBA B comm loss func is taken. Time
count starts when the communication link fails to
update the message.
As a rule of thumb, this parameter should be set to at
least 3 times the transmit interval of the master.
Note: There is a 60-second boot-up delay immediately
after power-up. During the delay, the communication
break monitoring is disabled (but communication itself
can be active).
FBA B comm loss
timeout 50.33
10 = 1 s / 10 = 1 s Time delay. 0.1 ... 6553.5 s
Auto / uint16 Selects the type and scaling of reference 1 received
from fieldbus adapter B.
See parameter
50.4 FBA A ref1 type .
FBA B ref1 type 50.34
Auto / uint16 Selects the type and scaling of reference 2 received
from fieldbus adapter B.
See parameter
50.4 FBA A ref1 type .
FBA B ref2 type 50.35
Auto / uint16 Selects the type/source and scaling of actual value 1
transmitted to the fieldbus network through fieldbus
adapter B.
See parameter
50.7 FBA A actual 1 type .
FBA B actual 1 type 50.37
Auto / uint16 Selects the type/source and scaling of actual value 2
transmitted to the fieldbus network through fieldbus
adapter B.
See parameter
50.8 FBA A actual 2 type .
FBA B actual 2 type 50.38
Not selected / uint32 Selects the source of the fieldbus status word when
the fieldbus adapter is set to a transparent
communication profile eg. by its configuration
parameters (group
54 FBA B settings ).
FBA B SW
transparent source 50.39
0 No source selected. Not selected
See Terms and abbreviations (page 130) . Other [value]
Not selected / uint32 When parameter 50.37 FBA B actual 1 type is set to
Transparent or General , this parameter selects the
source of actual value 1 transmitted to the fieldbus
network through fieldbus adapter B.
FBA B act1
transparent source 50.40
0 No source selected. Not selected
See Terms and abbreviations (page 130) . Other [value]
Parameters 385