ABB ACS880-34, Hardware Manual

Page: 198 / 256

198 Technical data
Markings
These markings are attached to the drive:
EMC compliance (IEC/EN 61800-3:2004)

Definitions
EMC stands for E lectro m agnetic C ompatibility. It is the ability of electrical/electronic
equipment to operate without problems within an electromagnetic environment. Likewise,
the equipment must not disturb or interfere with any other product or system within its
locality.
First environment includes establishments connected to a low-voltage network which
supplies buildings used for domestic purposes.
Second environment includes establishments connected to a network not supplying
domestic premises.
Drive of category C2 : drive of rated voltage less than 1000 V and intended to be installed
and started up only by a professional when used in the first environment.
Note : A professional is a person or organization having necessary skills in installing and/or
starting up power drive systems, including their EMC aspects.
Drive of category C3 : drive of rated voltage less than 1000 V and intended for use in the
second environment and not intended for use in the first environment.
Drive of category C4 : drive of rated voltage equal to or above 1000 V, or rated current
equal to or above 400 A, or intended for use in complex systems in the second
environment.

Category C2
The drive complies with the standard with the following provisions:
Mark Description
CE mark
Product complies with the applicable European Union legislation. For fulfilling the EMC
requirements, see section
EMC compliance (IEC/EN 61800-3:2004) on page 198 .
UL Listed mark for USA and Canada
Product has been tested and evaluated against the relevant North American standards by
Underwriters Laboratories.
Eurasian Conformity mark
Product complies with technical regulations of the Eurasian Customs Union. EAC marking is
required in Russia, Belarus and Kazakhstan.
EIP (Electronic Information Products) mark
Product does not contain toxic and hazardous substances or elements above the maximum
concentration values, and that it is an environmentally-friendly product which can be recycled
and reused.
The People’s Republic of China Electronic Industry Standard (SJ/T 11364-2014) specifies the
marking requirements for hazardous substances in electronic and electrical products.
Wheelie bin symbol
At the end of life the product should enter the recycling system at an appropriate collection point
and not placed in the normal waste stream. See
Disposal on page 197 .