ABB ACS880-14, Hardware Manual

Page: 74 / 248

Optional input power cable connection terminals and
ground busbar assembly (+H370)
Install the metallic shroud with ground bar as shown below.
Combi screw M4×8
Torx T20 2 N·m
Connect the input power cable connection terminals as shown in Step-by-step drawings for
an installation example of standard drive configuration in Rittal VX25 800 mm wide
enclosure (page 233)
.
Drive module without full-size output cable connection
terminals (0H371) and IP20 shrouds (0B051)
The power cables can be connected directly to the drive module input and output terminals
with cable lugs or by busbars. The drive module can also be installed self standing on the
floor in an electrical equipment room when the power cable terminals and electrical parts
are protected against contact and the drive module is grounded correctly.
74 Mechanical installation
4