ABB ACS880-04F-504A-3, Hardware Manual

Page: 137 / 202

Note: To achieve the rated motor power given in the table, the rated current of the drive must be higher
than or equal to the rated motor current. The power ratings apply to most IEC 34 motors at the nominal
voltage of the drive.
ABB recommends to select the drive, motor and gear combination for the required motion profile with
the DriveSize dimensioning tool available from ABB.
￭
High speed mode
The selection High speed mode of parameter 95.15 Special HW settings improves
control performance at high output frequencies. ABB recommends it to be selected
with output frequency of 120 Hz and above.
This table gives the drive module ratings for 120 Hz output frequency and the maximum
output frequency when High speed mode in parameter 95.15 Special HW settings is
enabled. With output frequencies lower than the maximum output frequency, the
current derating is less than the value given in the table. Contact ABB for operation
above the recommended maximum output frequency or for the output current derating
with output frequencies above 120 Hz and below the maximum output frequency.
Deratings with selection High speed mode of parameter 95.15 Special HW settings
ACS880-
04F-…
Maximum output frequency 120 Hz output frequency
Heavy-
duty
use
Light-
duty
use
Nominal use
Maxim-
um fre-
quency
Heavy-
duty
use
Light-
duty
use
Nominal use
Fre-
quency
I
Hd
I
Ld
P
n
I
2
f
max
I
Hd
I
Ld
P
n
I
2
f
A A kW A Hz A A kW A Hz
U
n
= 400 V
290 370 200 390 500 361 485 250 504 120 504A-3
311 419 250 437 500 429 575 315 584 120 584A-3
346 466 250 485 500 477 634 355 649 120 649A-3
390 496 250 519 500 566 715 400 725 120 725A-3
431 562 315 587 500 625 810 450 820 120 820A-3
500* 600 355 630 500 725* 865 500 880 120 880A-3
U
n
= 500 V
265 345 250 357 500 330 450 315 459 120 459A-5
290 370 250 390 500 361 483 355 502 120 502A-5
298 380 250 400 500 414 573 400 582 120 582A-5
298 392 250 410 500 477 623 450 634 120 634A-5
362 428 315 462 500 566 705 500 715 120 715A-5
400 490 355 530 500 625 807 560 820 120 820A-5
410 510 400 550 500 697** 857 630 880 120 880A-5
U
n
= 690 V
157 222 200 232 375 255 320 315 329 120 329A-7
200 250 250 260 375 325 360 355 369 120 369A-7
236*** 280 250 290 375 360*** 420 400 429 120 429A-7
238 261 250 270 375 415 455 450 470 120 470A-7
262 290 250 300 375 455 505 500 522 120 522A-7
300 330 315 340 375 505 571 560 590 120 590A-7
Technical data 137