ABB ACS880-04F-504A-3, Hardware Manual

Page: 113 / 202

Start-up
Contents of this chapter
This chapter describes the start-up procedure of the drive.
Reforming the capacitors
The capacitors must be reformed if the drive has not been powered (either in storage
or unused) for a year or more. The manufacturing date is on the type designation label.
For information on reforming the capacitors, refer to
Capacitor reforming instructions
(3BFE64059629 [English]) .
Start-up procedure
1. Only qualified electrical professionals are allowed to start-up the drive.
2. Make sure that the installation of the drive module has been checked according
to the checklist in chapter
Installation checklist, and that the motor and driven
equipment are ready for start.
3. Perform the start-up tasks instructed by the cabinet-installer of the drive module.
4. Switch the power on, setup the drive control program, and perform the first start
of the drive and motor. See
Quick start-up guide for ACS880 drives with primary
control program (3AUA0000098062 [English]) or ACS880 primary control program
firmware manual (3AUA0000085967 [English]) . If you need more information on
the use of the control panel, see ACS-AP-I, -S, -W and ACH-AP-H, -W Assistant
control panels user's manual (3AUA0000085685 [English]) .
10
Start-up 113
12