ABB ACS880-01 Series, Firmware Instructions

Page: 304 / 664

304 Parameters
Selected 1. 1
DI1 Digital input DI1 ( 10.02 DI delayed status , bit 0). 2
DI2 Digital input DI2 ( 10.02 DI delayed status , bit 1). 3
DI3 Digital input DI3 ( 10.02 DI delayed status , bit 2). 4
DI4 Digital input DI4 ( 10.02 DI delayed status , bit 3). 5
DI5 Digital input DI5 ( 10.02 DI delayed status , bit 4). 6
DI6 Digital input DI6 ( 10.02 DI delayed status , bit 5). 7
DIO1 Digital input/output DIO1 ( 11.02 DIO delayed status , bit 0). 10
DIO2 Digital input/output DIO2 ( 11.02 DIO delayed status , bit 1). 11
FBA A MCW bit 7 Control word bit 7 received through fieldbus interface A. 30
EFB MCW bit 7 Control word bit 7 received through the embedded fieldbus
interface. 32
Other [bit] Source selection (see Terms and abbreviations on page 148 ). -
31.12 Autoreset selection Selects faults that are automatically reset. The parameter is a
16-bit word with each bit corresponding to a fault type.
Whenever a bit is set to 1, the corresponding fault is
automatically reset.
The number and interval of reset attempts are defined by
parameters
31.14 … 31.16 .
WARNING! Before you activate the function, make
sure that no dangerous situations can occur. The
function resets the drive automatically and continues
operation after a fault.
Notes:
• The autoreset function is only available in external control;
see section Local control vs. external control (page 24 ).
• Faults related to the Safe torque off (STO) function cannot
be automatically reset.
The bits of this binary number correspond to the following
faults:
0000h
0000h…FFFFh Automatic reset configuration word. 1 = 1
No. Name/Value Description Def / FbEq16
Bit Fault
0 Overcurrent
1 Overvoltage
2 Undervoltage
3 AI supervision fault
4 Supply unit
5…7 Reserved
8 Application fault 1 (defined in the application program)
9 Application fault 2 (defined in the application program)
10 Selectable fault (see parameter 31.13 User selectable fault )
11 External fault 1 (from source selected by parameter 31.01 External event 1 source )
12 External fault 2 (from source selected by parameter 31.03 External event 2 source )
13 External fault 3 (from source selected by parameter 31.05 External event 3 source )
14 External fault 4 (from source selected by parameter 31.07 External event 4 source )
15 External fault 5 (from source selected by parameter 31.09 External event 5 source )