ABB ACS850 series, Firmware Manual

Page: 188 / 260

188 Parameters
57.13 Next ref1 mc grp Specifies the next multicast group of drives the multicast
message is relayed to. See parameter
57.11 Ref1 msg type .
This parameter is effective only in the master or intermediate
followers (i.e. followers relaying the message to other
followers).
0 No group selected. 0
1…62 Next multicast group in the chain. 1 = 1
57.14 Nr ref1 mc grps In the master drive, sets the total number of links (followers or
groups of followers) in the multicast message chain. See
parameter
57.11 Ref1 msg type .
Notes:
• This parameter has no effect if the drive is a follower.
• The master counts as a member of the chain if
acknowledgement from the last drive to the master is
desired.
1…62 Number of links in the multicast chain. 1 = 1
57.15 D2D com port Defines the hardware to which the drive-to-drive link is
connected. In special cases (such as harsh operating
conditions), the galvanic isolation provided by the RS-485
interface of the FMBA module may make for more robust
communication than the standard drive-to-drive connection.
on-board Connector X5 on the JCU Control Unit is used. 0
Slot 1 An FMBA module installed in JCU option slot 1 is used. 1
Slot 2 An FMBA module installed in JCU option slot 2 is used. 2
Slot 3 An FMBA module installed in JCU option slot 3 is used. 3
64
64 Load analyzer
Peak value and amplitude logger settings. See also section
Load analyzer on page 34 .
64.01 PVL signal Selects the signal to be monitored by the peak value logger.
The signal is filtered using the filtering time specified by
parameter
64.02 PVL filt time .
The peak value is stored, along with other pre-selected
signals at the time, into parameters
64.06 … 64.11 .
Parameter 64.03 Reset loggers resets both the peak value
logger and amplitude logger 2. The latest time the loggers
were reset is stored into parameter
64.13 .
Speed rpm 01.01 Motor speed rpm (see page 64 ). 1073742081
Speed % 01.02 Motor speed % (see page 64 ). 1073742082
Frequency 01.03 Output frequency (see page 64 ). 1073742083
Current 01.04 Motor current (see page 64 ). 1073742084
Current % 01.05 Motor current % (see page 64 ). 1073742085
Torque 01.06 Motor torque (see page 64 ). 1073742086
Dc-voltage 01.07 Dc-voltage (see page 64 ). 1073742087
Power inu 01.22 Power inu out (see page 64 ). 1073742102
Power motor 01.23 Motor power (see page 64 ). 1073742103
Process act 04.03 Process act (see page 72 ). 1073742851
Proc PID out 04.05 Process PID out (see page 72 ). 1073742853
Pointer Value pointer setting (see Terms and abbreviations on page
63 ).
-
No. Name/Value Description FbEq