ABB ACS850 series, Quick Start Up Manual

Page: 13 / 196

Quick Start-up Guide for ACS850 with Standard Control Program 13
After the text “Done OK” appears on the control panel, press OK to complete the
firmware assistant.
4 – Reference selection
In the Main menu, highlight ASSISTANTS and press
ENTER.
Highlight Reference select and press OK.
The following parameters will be set.
Note: Depending on the selections you make, the
routine may skip some of the parameters listed
below.
Select the control mode for external control
locations EXT1 and EXT2.
Speed: Speed control.
Torque: Torque control.
Min, Max, Add: Torque reference and speed
controller output are compared and the
mathematical function is applied (smaller, greater,
addition).
Depending on the selections, the speed or torque
reference source (or both) is defined next.
12.03 Ext1 ctrl mode
12.05 Ext2 ctrl mode
Speed reference set-up
Choose the number of constant speeds (if any) to use.
If you select any constant speeds, you are asked if the start direction should affect the
constant speed direction.
No: The sign of the constant speed directly determines the running direction when the
constant speed is activated.
Yes: The sign of the constant speed is multiplied by the value of the Direction signal to
determine the running direction when the constant speed is activated.
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT ENTER
MAIN MENU 1
LOC
Select assistant
Motor Set-up
Start/Stop Control
Reference select
EXIT OK
CHOICE LOC