ABB ACS850-04 series, Hardware Manual

Page: 136 / 164

Technical data
136
CE marking
A CE mark is attached to the drive to verify that the unit follows the provisions of the
European Low Voltage and EMC Directives. The CE marking also verifies that the
drive, in regard to its safety functions (such as Safe torque off), conforms with the
Machinery Directive as a safety component.
Compliance with the European Low Voltage Directive
The compliance with the European Low Voltage Directive has been verified
according to standards EN 60204-1 and EN 61800-5-1.
Compliance with the European EMC Directive
The EMC Directive defines the requirements for immunity and emissions of electrical
equipment used within the European Union. The EMC product standard
(EN 61800-3:2004) covers requirements stated for drives. See section
Compliance
with EN 61800-3:2004 below.
Compliance with the European Machinery Directive
The drive is an electronic product which is covered by the European Low Voltage
Directive. However, the drive includes the Safe torque off function and can be
equipped with other safety functions for machinery which, as safety components, are
in the scope of the Machinery Directive. These functions of the drive comply with
European harmonized standards such as EN 61800-5-2. The declaration of
conformity for the Safe torque off function is in the appropriate function-specific
manual,
Safe torque off function for ACSM1, ACS850 and ACQ810 drives
application guide (3AFE68929814 [English]).
Compliance with EN 61800-3:2004
Definitions
EMC stands for E lectro m agnetic C ompatibility. It is the ability of electrical/electronic
equipment to operate without problems within an electromagnetic environment.
Likewise, the equipment must not disturb or interfere with any other product or
system within its locality.
First environment includes establishments connected to a low-voltage network which
supplies buildings used for domestic purposes.
Second environment includes establishments connected to a network not supplying
domestic premises.
Drive of category C3: drive of rated voltage less than 1000 V and intended for use in
the second environment and not intended for use in the first environment.
Drive of category C4: drive of rated voltage equal to or above 1000 V, or rated
current equal to or above 400 A, or intended for use in complex systems in the
second environment.