ABB ACS580-01 drives, Manual

Page: 34 / 82

176 EN – R5 Quick installation guide
R0-
R4
R5
R6-
R9
EN
DA
DE
ES
FI
FR
IT
NL
PL
PT
RU
SV
TR
ZH
Select the power cables
Size the power cables according to local regulations to carry the nominal current
given on the type designation label of your drive.
Ensure the cooling
See table
I
on page
173
(UL: table
II
on page
173
) for the losses. The allowed
operating temperature range of the drive is -15 to +50 °C (+5 to +122 °F).No
condensation or frost is allowed. For more information on the ambient temperature
and derating, see chapter
Technical data
in
ACS580-01 (0.75 to 250 kW, 1.0 to
350 hp) hardware manual
(3AXD50000044794 [English]).
Protect the drive and input power cable
See tables
III
(on page
173
) and
IV
(on page
173
); (UL: table
V
on page
174
) for the
fuses.
If you use gG fuses, make sure that the operating time of the fuse is below 0.5
seconds. Follow the local regulations.
Install the drive on the wall
See figure
R5 Figures A
on page
435
.
Check the insulation of the power cables and the motor
Check the insulation of the input cable according to local regulations before
connecting it to the drive.
See figure
B
on page
435
.
1. Check the insulation of the motor cable and motor when the cable is disconnected
from the drive. Measure the insulation resistance between each phase conductor
and then between each phase conductor and the Protective Earth conductor
using a measuring voltage of 1000 V DC. The insulation resistance of an ABB
motor must exceed 100 Mohm (reference value at 25 °C or 77 °F). For the
insulation resistance of other motors, see the manufacturer’s instructions.
Note: Moisture inside the motor casing will reduce the insulation resistance. If
moisture is suspected, dry the motor and repeat the measurement.