ABB ACS560, Firmware Manual

Page: 478 / 514

478 Fieldbus control through a fieldbus adapter
Automatic drive configuration for fieldbus control
The parameters set on module detection are shown in the table below. See also
parameters
07.35 Drive configuration and 07.36 Drive configuration 2 .
Notes:
• The optional modules BIO-01 and RIIO-01 are applicable only for frames R0...R2.
• No parameter changes are done for C-series modules. c-series modules are only
supported in frames R3...R8.
Option
10.24 RO1
source
10.27 RO2
source
10.30 RO3
source
20.01 Ext1
commands
20.03 Ext1
in1 source
20.04 Ext1
in2 source
BIO-01 - - - 2 (In1 Start,
In2 Dir)
2 (DI1) 3 (DI2)
RIIO-01 - - - 2 (In1 Start,
In2 Dir)
2 (DI1) 3 (DI2)
FENA-21 - - - - - -
FECA-01 - - - - - -
FPBA-01 - - - - - -
FCAN-01 - - - - - -
FSCA-01 - - - - - -
FEIP-21 - - - - - -
FMBT-21 - - - - - -
FPNO-21 - - - - - -
FEPL-02 - - - - - -
FDNA-01 - - - - - -
FCNA-01 - - - - - -
Option
22.11 Ext1
speed ref1
22.22
Constant
speed sel1
22.23
Constant
speed sel2
BIO-01 1 (AI1
scaled)
4 (DI3) 5 (DI4)
RIIO-01 1 (AI1
scaled)
4 (DI3) 5 (DI4)
FENA-21 - - -
FECA-01 - - -
FPBA-01 - - -
FCAN-01 - - -
FSCA-01 - - -
FEIP-21 - - -
FMBT-21 - - -
FPNO-21 - - -
FEPL-02 - - -
FDNA-01 - - -
FCNA-01 - - -