ABB ACS560, Firmware Manual

Page: 420 / 514

420 Fault tracing
0003 Relay output 3 Select a different signal with parameter
10.30 RO3 source .
A8B0 Signal supervision 1
(Editable message text)
Programmable warning:
32.06 Supervision 1 action
Warning generated by the
signal supervision function 1. Check the source of the warning
(parameter
32.07 Supervision 1 signal ).
A8B1 Signal supervision 2
(Editable message text)
Programmable warning:
32.16 Supervision 2 action
Warning generated by the
signal supervision function 2. Check the source of the warning
(parameter
32.17 Supervision 2 signal ).
A8B2 Signal supervision 3
(Editable message text)
Programmable warning:
32.26 Supervision 3 action
Warning generated by the
signal supervision function 3. Check the source of the warning
(parameter
32.27 Supervision 3 signal ).
A8B3 Signal supervision 4
(Editable message text)
Programmable warning:
32.36 Supervision 4 action
Warning generated by the
signal supervision function 4. Check the source of the warning
(parameter
32.37 Supervision 4 signal ).
A8B4 Signal supervision 5
(Editable message text)
Programmable warning:
32.46 Supervision 5 action
Warning generated by the
signal supervision function 5. Check the source of the warning
(parameter
32.47 Supervision 5 signal ).
A8B5 Signal supervision 6
(Editable message text)
Programmable warning:
32.56 Supervision 6 action
Warning generated by the
signal supervision function 6. Check the source of the warning
(parameter
32.57 Supervision 6 signal ).
A8B6 Current limit Motor actual current exceeded
the limit defined in parameter
30.17 Maximum current .
Reduce the motor load. Check for any
jam or stall in motor.
A8BE ULC overload warning User load curve: Signal has
been too long over the
overload curve.
See parameter 37.03 ULC overload
actions .
001 Overload occurred between
speed point 37.11 ULC speed
table point 1 and 37.12 ULC
speed table point 2 .
Check the load.
002 Overload occurred between
speed point 37.12 ULC speed
table point 2 and 37.13 ULC
speed table point 3 .
Check the load.
003 Overload occurred between
speed point 37.13 ULC speed
table point 3 and 37.14 ULC
speed table point 4 .
Check the load.
004 Overload occurred between
speed point 37.14 ULC speed
table point 4 and 37.15 ULC
speed table point 5 .
Check the load.
A8BF ULC underload
warning User load curve: Signal has
been too long under the
underload curve. See parameter 37.04 ULC underload
actions .
Code
(hex)
Warning / Aux. code
( aux code visible only
on assistant control
panel and drive
composer
)
Cause What to do