Introduction to the manual 11
1
Introduction to the manual
Contents of this chapter
The chapter describes applicability, target audience and purpose of this manual. It
also describes the contents of this manual and refers to a list of related manuals for
more information.
Applicability
The manual applies to the ACS560 standard control program (IGPKA version 2.10.03
or later).
To check the firmware version of the control program in use, see system information
parameter
(see page
) on the control panel.
Safety instructions
Follow all safety instructions.
• Read the
complete safety instructions
in the
Hardware manual
of the drive
before you install, commission, or use the drive.
• Read the
firmware function-specific warnings and notes
before changing
parameter values. These warnings and notes are included in the parameter
descriptions presented in chapter
on page
.
Target audience
The reader is expected to know the fundamentals of electricity, wiring, electrical
components and electrical schematic symbols.
The manual is written for readers worldwide.
Summary of Contents for ACS560
