ABB ACS380 Series, Hardware Manual

Page: 76 / 186

76 Electrical installation

To remove a front option
1. Disconnect the control cables from the option module.
2. Loosen the locking screw.
3. Carefully pull the option module to disconnect it. Note that the option module can
be tightly in position.

To install a side option
1. Remove the two screws from the front-
most grounding clamp at the bottom of
the drive.
2. Carefully align the side option with the
connectors on the right side of the drive.
3. Fully push the option module into position.
4. Tighten the locking screw of the option
module.
5. Attach the grounding bar to the bottom of
the side option and to the front ground tab
on the drive.
6. Connect the applicable control cables
according to Connecting the control
cables on page 68 .

To remove a side option
1. Disconnect the control cables from the side option.
2. Open the grounding bar screws.
3. Loosen the locking screw.
4. Carefully remove the side option from the drive. Note that the option module can
be tightly in position.
1
2
3
4
5
6