ABB ACS350 Series, User Manual

Page: 76 / 314

Control panels
76
Assistants mode
When the drive is first powered up, the Start-up Assistant guides you through the
setup of the basic parameters. The Start-up Assistant is divided into assistants, each
of which is responsible for the specification of a related parameter set, for example
Motor Set-up or PID Control. The Start-up Assistant activates the assistants one
after the other. You may also use the assistants independently. For more information
on the tasks of the assistants, see section
Start-up Assistant on page 95 .
In the Assistants mode, you can:
• use assistants to guide you through the specification of a set of basic parameters
• start, stop, change the direction and switch between local and remote control.
How to use an assistant
The table below shows the basic operation sequence which leads you through
assistants. The Motor Set-up Assistant is used as an example.
Step Action Display
1. Go to the Main menu by pressing if you are in the Output mode, otherwise
by pressing repeatedly until you get to the Main menu.
2. Go to the Assistants mode by selecting ASSISTANTS on the menu with keys
and , and pressing .
3. Select the assistant with keys and , and press .
If you select any other assistant than the Start-up Assistant, it guides you
through the task of specification of its parameter set as shown in steps
4. and 5.
below. After that you can select another assistant on the Assistants menu or exit
the Assistants mode. The Motor Set-up Assistant is used here as an example.
If you select the Start-up Assistant, it activates the first assistant, which guides
you through the task of specification of its parameter set as shown in steps
4.
and 5. below. The Start-up Assistant then asks if you want to continue with the
next assistant or skip it – select the appropriate answer with keys and
, and press . If you choose to skip, the Start-up Assistant asks the
same question about the next assistant, and so on.
4. • To specify a new value, press keys and .
• To ask for information on the requested parameter, press key . Scroll the
help text with keys and . Close the help by pressing .
MENU
EXIT
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT ENTER 00:00
MAIN MENU 1 LOC
ENTER
Start-up assistant
Motor Set-up
Application
Speed control EXT1
Speed control EXT2
EXIT SEL 00:00
ASSISTANTS 1 LOC
SEL
9905 MOTOR NOM VOLT
PAR EDIT
220 V
EXIT SAVE
00:00
LOC
SEL
Do you want to
continue with
application setup?
Continue
Skip
EXIT OK 00:00
CHOICE LOC
9905 MOTOR NOM VOLT
PAR EDIT
240 V
EXIT SAVE 00:00
LOC
?
EXIT
EXIT 00:00
Set as given on the
motor nameplate.
Voltage value must
correspond to motor
D/Y connection.
HELP
LOC