ABB ACS280, Firmware Manual, Page: 290 / 430

290 Parameters
99.10 Motor nominal power
Defines the nominal motor power. The setting must
match the value on the rating plate of the motor. If
multiple motors are connected to the drive, enter the
total power of the motors. The unit is selected by
parameter
96.16 Unit selection
.
Note: This parameter cannot be changed while the
drive is running.
1.10 kW or hp
0.00… 10000.00 kW or
0.00… 13404.83 hp
Nominal power of the motor. 1 = 0.01 unit
(see par.
46.04
)
99.11 Motor nominal cos Φ
Defines the cosphi of the motor for a more accurate
motor model. This value is not obligatory, but is
useful with an
asynchronous motor, especially when performing a
standstill identification run. With a permanent
magnet or synchronous reluctance motor, this value
is not needed.
Notes:
• Do not enter an estimated value. If you do not know
the
• exact value, leave the parameter at zero.
• This parameter cannot be changed while the drive
is running.
0.00
0.00…1.00 Cosphi of the motor. 100 = 1
99.12 Motor nominal torque
Defines the nominal motor shaft torque for a more
accurate motor model. Not obligatory. The unit is
selected by parameter
96.16 Unit selection
.
Note: This parameter cannot be changed while the
drive is running.
0.000
N·m or lb·ft
0.000…4000000.000
N·m or
0.000…2950248.597
lb·ft
Nominal motor torque. 1 = 100 unit
No. Name/Value Description Default
FbEq 16