ABB ACS280, Firmware Manual, Page: 106 / 430

106 Parameters
06.20 Constant speed status
word
Constant speed/frequency status word. Indicates
which constant speed or frequency is active (if any).
See also parameter
06.19 Speed control status word
,
bit 7, and section Constant speeds/frequencies.
This parameter is read-only.
-
0000h…FFFFh Constant speed/frequency status word. 1 = 1
06.21 Drive status word 3 Drive status word 3.
This parameter is read-only. -
0000h…FFFFh Drive status word 1. 1 = 1
06.29 MSW bit 10 selection
Selects a binary source whose status is transmitted
as bit 10 of parameter
06.11 Main status word
.
Above limit
False 0. 0
True 1. 1
Above limit Bit 10 of
06.17 Drive status word 2
. 2
Other [bit]
Source selection (see
Terms and abbreviations
). -
06.30 MSW bit 11 selection
Selects a binary source whose status is transmitted
as bit 11 (User bit 0) of
06.11 Main status word
.
Ext ctrl loc
False 0. 0
True 1. 1
Ext ctrl loc Bit 11 of
06.01 Main control word
. 2
Other [bit]
Source selection (see
Terms and abbreviations
). -
06.31 MSW bit 12 selection
Selects a binary source whose status is transmitted
as bit 12 (User bit 1) of
06.11 Main status word
.
Ext run
enable
False 0. 0
True 1. 1
Ext run enable Status of the external run enable signal (see
parameter
20.12 Run enable 1 source
).
2
No. Name/Value Description Default
FbEq 16
Bit Name Description
0 Constant speed 1 1 = Constant speed or frequency 1 selected
1 Constant speed 2 1 = Constant speed or frequency 2 selected
2 Constant speed 3 1 = Constant speed or frequency 3 selected
3 Constant speed 4 1 = Constant speed or frequency 4 selected
4 Constant speed 5 1 = Constant speed or frequency 5 selected
5 Constant speed 6 1 = Constant speed or frequency 6 selected
6 Constant speed 7 1 = Constant speed or frequency 7 selected
7…15 Reserved
Bit Name Description
0 DC hold active 1 = DC hold is active
1 Post-magnetizing active 1 = Post-magnetizing is active
2 Motor pre-heating active 1 = Motor pre-heating is active
3 PM smooth start active 1 = PM smooth start is active
4 Rotor position known 1 = Rotor position is known
5 DC brake active 1 = DC brake is active
6…15 Reserved