ABB ACS180, Firmware Manual, Page: 218 / 392

218 Parameters
32.29 Supervision 3 low Defines the lower limit for signal supervision 3. 0.00
-21474830.00…
21474830.00 Low limit. -
32.30 Supervision 3 high Defines the upper limit for signal supervision 3. 0.00
-21474830.00…
21474830.00 Upper limit. -
32.31 Supervision 3
hysteresis Defines the hysteresis for the signal monitored by signal
supervision 3.
Note : This parameter applies to all selections of
parameter 32.25 , not just Hysteresis.
0.00
0.00…100000.00 Hysteresis. -
32.35 Supervision 4 function Selects the mode of signal supervision function 4.
Determines how the monitored signal (see parameter
32.37 is compared to its lower and upper limits ( 32.39 and
32.30 respectively). The action to be taken when the
condition is fulfilled is selected by 32.36 .
Disabled
Disabled Signal supervision 4 not in use. 0
Low Action is taken whenever the signal falls below its lower
limit. 1
High Action is taken whenever the signal rises above its upper
limit. 2
Abs low Action is taken whenever the absolute value of the signal
falls below its (absolute) lower limit. 3
Abs high Action is taken whenever the absolute value of the signal
rises above its (absolute) upper limit. 4
Both Action is taken whenever the signal falls below its low limit
or rises above its high limit. 5
Abs both Action is taken whenever the absolute value of the signal
falls below its (absolute) low limit or rises above its
(absolute) high limit. 6
Hysteresis Action is taken whenever the signal rises above the value
defined by the high limit + 0.5 · hysteresis range (
32.41
Supervision 4 hysteresis ). The action is deactivated when
the signal falls below the value defined by the low limit -
0.5 · hysteresis range.
7
32.36 Supervision 4 action Selects whether the drive generates a fault, warning or
neither when the value monitored by signal supervision 4
exceeds its limits.
Note: This parameter does not affect the status indicated
by 32.01 Supervision status .
No action
No action No warning or fault generated. 0
Warning Warning A8B0 Signal supervision is generated. 1
Fault The drive trips on fault 80B0 Signal supervision . 2
Fault if running The drive trips on fault 80B0 Signal supervision if running. 3
32.37 Supervision 4 signal Selects the signal to be monitored by signal supervision
function 4.
For the available selections, see parameter
32.07
Supervision 1 signal .
Zero
No. Name/Value Description Default
FbEq 16
ACS180 FW.book Page 218 Tuesday, March 9, 2021 2:25 PM