ABB ACS1000i air-cooled, User Manual

Page: 77 / 174

05 TRANSPORTATION, STORAGE AND DISPOSAL
3BHS206977 E01 REV H ACS1000I AIR-COOLED USER MANUAL 77/174
5.5.3 Storage and handling of spare parts
NOTICE
Check the spare parts immediately after receipt for damages. Report any damage to the
shipping company and the ABB service organization.
Observe the following to maintain spare parts in good condition and to keep the warranty valid
during the warranty period:
- Keep spare parts in their original packaging
- Store printed circuit boards in anti-static bags or boxes
- Storage temperature range: -5 °C – +55 °C
- Storage place requirements:
• Free of vibration and shock
• Protected against dust, sand, vermin and insects
• Free of corrosive gases, salt or other impurities that could damage
electronic equipment
• Dry with no condensation
• Relative air humidity: 5 – 85%
If in doubt whether the maximum allowed humidity is exceeded, protect the spare parts
by an external heater.
- Do not touch a component without wearing a wrist grounding strap.
- Put the component on a grounded working surface protected against
electrostatic discharges
- Hold the component only at the edge
5.6 Disposal of packaging materials and components
Apply ESD handling precautions before handling these devices.
Electronic devices (eg, circuit boards, semiconductors) are sensitive to
electrostatic discharge (ESD), which can damage these devices.
Dispose of the packaging materials and the components at the end of the lifetime
of the drive according to local regulations.