ABB ACS1000i air-cooled, User Manual

Page: 137 / 174

10 CDP CONTROL PANEL
3BHS206977 E01 REV H ACS1000I AIR-COOLED USER MANUAL 137/174
10.3.3 Parameters mode
NOTICE
10.3.3.1 Overview
If the parameter lock is disabled or unlocked (see “10.3.3.3 Enabling / unlocking a parameter
lock” on page 141), the parameters mode allows entering the parameter settings for the
required drive configuration depending on the application.
The parameters are organized in functional groups, so called parameter groups.
When entering the parameter mode for the first time after the auxiliary voltage of the drive has
been switched on, the CDP control panel displays the first parameter of parameter group 99.
The next time the parameters mode is entered, the previously selected parameter displays.
Some parameter values cannot be changed while the drive is running. If tried, the following
warning displays.
Running the drive system with incorrect data can result in improper operation, reduction of
control accuracy and damage to equipment.
- Parameters must only be set by qualified personnel.
- Do not change any parameter, if the meaning of the parameter and the effects of the
change are not fully understood.
Group Description
Group 07 Control words
Group 08 Status words
Group 09 Fault and alarm words
Group 11 Start, stop, direction, MCB and control
Group 12 Reference selection
Group 13 Basic analog inputs
Group 14 Basic digital outputs
Group 15 Basic analog outputs
Group 16 System control inputs
Group 17 Utilities
Group 18 Process speed
Group 19 Data storage
Group 20 Limits
Group 21 Start, stop and process stop
Group 22 Ramp functions
Group 23 Speed reference
For details about the parameters, their settings and functions, see
“Appendix G – Signal and parameter table”.