ABB ACQ810, Firmware Manual

Page: 185 / 376

Parameters 185
25.05 Crit speed2 hi Defines the high limit for critical speed range 2.
Note: This value must be greater than or equal to the value
of 25.04 Crit speed2 lo .
-30000 … 30000
rpm High limit for critical speed 2. 1 = 1 rpm
25.06 Crit speed3 lo Defines the low limit for critical speed range 3.
Note: This value must be less than or equal to the value of
25.07 Crit speed3 hi .
-30000 … 30000
rpm Low limit for critical speed 3. 1 = 1 rpm
25.07 Crit speed3 hi Defines the high limit for critical speed range 3.
Note: This value must be greater than or equal to the value
of 25.06 Crit speed3 lo .
-30000 … 30000
rpm High limit for critical speed 3. 1 = 1 rpm
26
26 Constant speeds Constant speed selection and values.
An active constant speed overrides the drive speed
reference. See also section
Constant speeds on page 68 .
26.01 Const speed func Determines how constant speeds are selected, and whether
the rotation direction signal is considered or not when
applying a constant speed.
No. Name/Value Description FbEq
Bit Name Information
0
Const speed
mode
1 = Packed: 7 constant speeds are selectable using the three sources
defined by parameters
26.02 , 26.03 and 26.04 .
0 = Separate: Constant speeds 1, 2 and 3 are separately activated by
the sources defined by parameters
26.02 , 26.03 and 26.04 respectively.
In case of conflict, the constant speed with the smaller number takes
priority.
1 Dir ena
1 = Start dir: To determine running direction for a constant speed, the
sign of the constant speed setting (parameters
26.06 … 26.12 ) is
multiplied by the direction signal (forward: +1, reverse: -1). For example,
if the direction signal is reverse and the active constant speed is
negative, the drive will run in the forward direction.
0 = Accord Par: The running direction for the constant speed is
determined by the sign of the constant speed setting (parameters
26.06 … 26.12 ).