ABB ACQ800 Series, Hardware Manual

Page: 89 / 140

ACQ800-37 Hardware Manual 89
Installation checklist and start-up
Default values of parameters with the ACQ800-37
When the IGBT Supply Control Program is loaded into the ACQ800-37, the following
parameters receive the default values given in the table below. Do not change the
default values. If they are changed, the drive will not operate properly.
31.01 NUMBER OF TRIALS Defines the number of automatic fault resets the drive performs within
the time defined by parameter 31.02.
Note: When the value of parameter is not 0 and parameter 98.02
COMM. MODULE is set to INU COM LIM, sending a fault bit of 08.01
MAIN STATUS WORD to inverter side is delayed 1 s to get time for
line-converter automatic reset function.
I 0
0 … 5 Number of the automatic resets 0
31.02 TRIAL TIME Defines the time for the automatic fault reset function. See parameter
31.01. R 30 s
1.0 … 180.0 s Allowed resetting time 100 …
18000
31.03 DELAY TIME Defines the time that the drive will wait after a fault before attempting
an automatic reset. See parameter 31.01. R 0 s
0.0 … 3.0 s Resetting delay 0 … 300
31.04 OVERCURRENT Activates/deactivates the automatic reset for the line converter
overcurrent fault. B NO
NO Inactive 0
YES Active 65535
31.05 OVERVOLTAGE Activates/deactivates the automatic reset for the intermediate link
overvoltage fault. B NO
NO Inactive 0
YES Active 65535
31.06 UNDERVOLTAGE Activates/deactivates the automatic reset for the intermediate link
undervoltage fault. B NO
NO Inactive 0
YES Active 65535
Parameter Default value
11.01 DC REF SELECT FIELDBUS
11.02 Q REF SELECT PARAM 24.02
70.01 CH0 NODE ADDR 120
70.19 DDCS CH0 HW CONN RING
70.20 CH3 HW CONNECTION RING
71.01 CH0 DRIVEBUS MODE NO
98.01 COMMAND SEL MCW
98.02 COMM. MODULE INU COM LIM
No. Name/Value Description T./FbEq Def.