ABB ACQ80, Firmware Manual

Page: 247 / 390

Parameters 247
External 24V The drive control board is powered from an
external power
supply. 1
95.15 Special HW
settings
Contains hardware-related settings that can be
enabled and disabled by toggling the specific
bits.
Note: The installation of the hardware specified
by this parameter may require derating of drive
output, or impose other limitations. Refer to the
hardware manual of the drive.
0b0000
0b0000…0b111
1 Hardware options configuration word. 1 = 1
95.20 HW options word
1
Specifies hardware-related options that require
differentiated parameter defaults.
This parameter is not affected by a parameter
restore. 0b0000
0b0000…
0b1111 Hardware options configuration word. 1 = 1
No. Name/Value Description Def/
FbEq16
Bit Name Information
0 Reserved
1 ABB Sine filter 1 = An ABB sine filter is connected to the output of the
drive.
2…15 Reserved
Bit Name Value
0 Supply
frequency 60
Hz
If you change the value of this bit, you have to do a
complete reset to the drive after the change. After
reset you have to reselect the macro to be used.
See section
Differences in the default values between
50 Hz and 60 Hz supply frequency settings
on page
272
.
0 = 50 Hz.
1 = 60 Hz.
1…12 Reserved
13 du/dt filter
activation When active, an external du/dt filter is connected to
the drive/inverter output. The setting will limit the
output switching frequency, and force the fan of the
drive/inverter module to full speed.
0 = du/dt filter inactive.
1 = du/dt filter active.
14…15 Reserved