ABB ACQ80-04 Series, Firmware Manual

Page: 140 / 270

140 Parameters
40.97 Process PID
feedback% Percentage scaled signal of parameter 40.02 Process PID
feedback actual . Correct later.
0.00
-100.00...100.00% Percentage. 1=1
40.98 Process PID
setpoint% Percentage scaled signal of parameter 40.03 Process PID
setpoint actual .Correct later.
0.00
-100.00...100.00% Percentage. 1=1
40.99 Process PID
deviation% Percentage scaled signal of parameter 40.04 Process PID
deviation actual .Correct later.
0.00
-100.00...100.00% .Percentage. 1=1
46
46 Monitoring/scaling
settings Speed supervision settings; actual signal filtering; general
scaling settings.
46.01 Speed scaling Defines the maximum speed value used to define the
acceleration ramp rate and the initial speed value used to
define the deceleration ramp rate (see parameter group
23
Speed reference ramp ). The speed acceleration and
deceleration ramp times are therefore related to this value
(
not to parameter 30.12 Maximum speed ).
Also defines the 16-bit scaling of speed-related parameters.
The value of this parameter corresponds to 20000 in eg.
fieldbus communication.
1500.00 rpm
0.10…30000.00
rpm Acceleration/deceleration terminal/initial speed. 1 = 1 rpm
46.02 Frequency scaling Defines the maximum frequency value used to define the
acceleration ramp rate and the initial frequency value used to
define deceleration ramp rate (see parameter group
28
Frequency reference chain ). The frequency acceleration and
deceleration ramp times are therefore related to this value
(
not to parameter 30.14 Maximum frequency .
Also defines the 16-bit scaling of frequency-related
parameters. The value of this parameter corresponds to
20000 in eg. fieldbus communication.
50.00 Hz
0.10…1000.00 Hz Acceleration/deceleration terminal/initial frequency. 10 = 1 Hz
46.03 Torque scaling Defines the 16-bit scaling of torque parameters. The value of
this parameter (in percent of nominal motor torque)
corresponds to 10000 in eg. fieldbus communication. 100.0%
0.1…1000.0% Torque corresponding to 10000 on fieldbus. 10 = 1%
46.04 Power scaling Defines the output power value that corresponds to 10000 in
eg. fieldbus communication. The unit is selected by
parameter
96.16 Unit selection .
1000.00 kW
or hp
0.10 …30000.00
kW or
0.10 …40200.00 hp Power corresponding to 10000 on fieldbus. 1 = 1 unit
46.05 Current scaling Defines the 16-bit scaling of current parameters. The value of
this parameter corresponds to 10000 in fieldbus
communication. 10000 A
0…30000 A
No. Name/Value Description Def/FbEq16
ACQ80 FW.book Page 140 Thursday, February 14, 2019 11:33 AM