ABB ACQ580-07, Hardware Manual

Page: 78 / 324

„
a
b
120°
w
„
> 400 mm (15.75”)
Note 1: Any height adjustment must be done before attaching the cabinet sections to
the floor or to each other. Height adjustment can be done by using metal shims between
the cabinet bottom and floor.
Note 2: Depending on the size of the cabinet, it has either bolt-on lifting eyes, or lifting
bars with lifting holes. If the cabinet is delivered with lifting bars, remove them. Store
the bars for decommissioning. Bolt-on lifting eyes need not be removed unless the holes
are used for attaching the cabinet. Plug any unused holes using the existing bolts and
sealing rings included. Tighten to 70 N·m (52 lbf·ft).
„
￭
Attaching the cabinet (non-marine units)
Alternative 1 – Clamping
1. Insert the clamps (included) into the twin slots along the front and rear edges of the
cabinet frame body and fasten them to the floor with a bolt. The recommended
maximum distance between the clamps in the front edge is 800 mm (31.5”).
74 Mechanical installation
4