Commissioning
Product manual 2CKA001473B5285
│
20
7 Commissioning
The following prerequisites and system limits apply for commissioning the Weather station flex,
wireless.
Prerequisites
■
Operation and configuration app "ABB-free@home
®
App Next"
■
Registration at MyBuildings
■
Depending on the desired expansion stage of the operating mode, additional components
are required.
– Room control: Additional ABB-free@home
®
flex devices for the setup of a mesh network
are necessary.
– Home automation (SysAP): For integration in ABB-free@home
®
installation with a
System Access Point.
■
Setup of radio network: Several devices must be available and they must be visible
together, see .
System limits
■
Bluetooth
®
:
– The radio range between the devices amounts to a maximum of 10 meters.
– A
Bluetooth
®
connection is used for the connection between the smartphone and an
additional device. If thick walls are located within the planned radio line, the attainable
transmission ranges are greatly reduced.
– The same applies to connections on other floors. In this case the radio signals must
pass through floor ceilings.
■
Wireless 2.4 GHz:
– The radio range between the devices amounts to a maximum of 30 meters.
– If thick walls are located within the planned radio line, the attainable transmission ranges
are greatly reduced.
– The same applies to connections on other floors. In this case the radio signals must
pass through floor ceilings.
Special measures for commissioning are not required. The ABB-free@home
®
flex device is
ready for operation directly after connection and assembly.
The function of the respective device depends on the combination of ABB flexTronics
®
insert
and ABB-free@home
®
flex control element.
– If the sensor shows 1 rocker, the rocker is linked with the actuator function via default
(dimming, switching, blind).
– If the sensor shows 2 rockers (2gang sensor), the left rocker is linked with the actuator
function via default (dimming, switching, blind).
The right rocker has no function via default.
The further parameter setting is carried out via the ABB-free@home
®
App Next or the System
Access Point. Here both rockers can be freely linked and occupied with functions, e.g. for blind
control, see “Operation“ on page 44.
