![background image](http://html.mh-extra.com/html/abb/a170-m62/a170-m62_operation-manual_3412035.webp)
Operation Manual / A170-M.. - A175-M..
3 Removal and installation / 3.3 Installing the turbocharger
© Copyright 2021 ABB. All rights reserved.
HZTL4033_EN
Rev.H
July 2021
Removing auxiliary screws
Fig. 16: Removing auxiliary screw
u
Remove shipping screws (90334 / 90335) on the left and right side of the foot and place
in the toolbox.
The turbocharger is delivered with a pre-installed sliding block (68003). The shipping screws
secure the sliding block in the preset position. In operation, the foot can slip due to thermal
expansion.
u
Tighten clamping nuts as described in the following sections.
u
Connect all gas, air and oil pipes.
u
If present: Re-fit the insulation segments.
u
If present: Connect cable to speed sensor.
Compressor-end (CE) foot
Fig. 17: Compressor-end foot
Page
33
/
147