38
Notes.
Pressing advances to
the next main page, e.g. 2.2 to 3.0
Pressing advances to
the next sub-page, e.g. 5.0 to 5.1.
From Page 3
To
Page 0
Note.
If an incorrect security code is entered and
pressed access to the sub-pages is not allowed,
but the current page level is maintained.
Pressing displays Page 0.
Note.
Programming Pages
5.2 and 5.3 are displayed on 4 and
6 channel versions respectively
.
ALARM RELAY SETUP PAGE 5.0
Alaram relay configuration = Alarm
Alarm failsafe = YES
Alarm hysteresis = xx%
FACTORY SETTINGS PAGE 6.1
WARNING : These parameters are factory
set and should not normally require
adjustment. They can only be set up if
the necessary equipment is available.
DO NOT PROCEED WITHOUT CONSULTING THE
OPERATION MANUAL.
MULTISTREAM TIMING PAGE 6.8
Number of streams fitted = x
To
Page 6.2
SET UP CURRENT OUTPUT PAGE 4.0
Stream 1 O/P range = 0 to xxx<units>
Stream 2 O/P range = 0 to xxx<units>
Stream 3 O/P range = 0 to xxx<units>
Stream 4 O/P range = 0 to xxx<units>
Stream 5 O/P range = 0 to xxx<units>
Stream 6 O/P range = 0 to xxx<units>
SET UP CURRENT OUTPUT PAGE 4.1
Output type = xx to xx mA
Test output = NO
Up scale sample time = xx mins
Down scale sample time = xx
mins
SETUP ALARM CONCENTRATION PAGE 5.1
A1 enabled = NO
A1 setpoint = xxx <units>
A1 action = LOW
A2 enabled = NO
A2 setpoint = xxx <units>
A2 action = LOW
FACTORY SETTINGS PAGE 6.0
Eenter factory settings
security code xxxx
ELECTRICAL CALIBRATION PAGE 6.2
Reading = xxx<units>
Lamp alignment V read = x.xxx Volts
Lamp alignment V ref = x.xxx Volts
Alter factory settings
security code xxxx
ELECTRICAL CALIBRATION PAGE 6.3
Read I/P zero -2V xxxxx
Read I/P span +2V xxxxx
Ref I/P zero -2V xxxxx
Ref I/P span +2V xxxxx
ELECTRICAL CALIBRATION PAGE 6.4
Temperature chan1 zero 100
xxx.x
Temperature chan1 span 150
xxx.x
Temperature chan2 zero 100
xxx.x
Temperature chan2 span 150
xxx.x
ELECTRICAL CALIBRATION PAGE 6.5
Current output 1 - 4-20mA
Current output 2 - 4-20mA
Current output 3 - 4-20mA
Current output 4 - 4-20mA
Current output 5 - 4-20mA
Current output 6 - 4-20mA
CALIBRATION ALARM SETUP PAGE 6.7
Zero offset range=0.0
+/- xxx <units>
Cal factor range=
1.0
+/-x.xx
INSTRUMENT TIMING PAGE 6.6
Measured variable filter = ON
Optical filter = x
Cuvette filling time = xxx s
AUTO ZERO time = xxx min
SECONDARY CALIBRATION time = xxx min
Recovery on sample time = xxx min
…APPENDIX A – MULTI-STREAM PROGRAMMING
