Operation Manual / A130-H.. - A140-H..
9 Dismantling and fitting / 9.1 Introduction
© Copyright 2021 ABB. All rights reserved.
HZTL4030_EN
Rev.G
July 2021
9
Dismantling and fitting
9.1
Introduction
The precondition for the work described in the following is a turbocharger removed from the
engine (see chapter
).
WARNING
Danger of burns
Touching hot surfaces or contact with hot operating fluids can cause burns.
u
Do not touch hot surfaces. Observe the warning plate on the turbochar-
ger.
u
Wear heat-resistant safety gloves and protective clothing.
u
Wait for the turbocharger to cool down before carrying out any work.
Wear safety gloves to protect against thermal hazards.
WARNING
Cutting injuries when working on the turbocharger
Some parts on the turbocharger may have sharp edges. There is a risk of a
cutting injury.
u
Wear safety gloves against mechanical risks when conducting assembly
and disassembly work.
Wear safety gloves to protect against mechanical hazards.
WARNING
Non-observance of the work steps and further operations
Incorrectly performed work or further operations can cause injury to person-
nel or damage to the machine.
u
Only perform operations that are described in this document.
u
Only perform operations for which you have previously received instruc-
tion or training.
u
Have further operations carried out only by trained personnel from an
ABB Turbocharging Service Station.
u
Mark the casing position for assembly.
Identification of the assembly devices
Not all assembly devices are marked with a part number. Identification is guaranteed by the
tool list. This list is enclosed with the toolbox.
Page
78
/
122
Summary of Contents for 12285242
Page 2: ......
