USER MANUAL EN, PL,
6 |
S t r o n a
Use only the 2.0m DC power cable supplied with the Fridge/Freezer.
Operating your Fridge/Freezer 12V DC(Cont.)
Power Requirements
IMPORTANT
When using the Fridge/Freezer with 12V DC power supply, we recommended setting the Battery
Monitor to LOW.
If your Fridge/Freezer is cutting out prematurely, it could be due to:
1.
The low voltage protection being set too high on the Battery Monitor
2.
DC power cable and/or connections are not suitable to carry the required current. Check the
power cable and all connections and adjust the Battery Monitor switch at the rear of the unit.
NOTE: A battery charger may only be connected to the battery when the Fridge/Freezer has been
disconnected from the DC power source.
Over-voltage may cause damage to the electronics of the Fridge/Freezer.
Your Fridge/Freezer is equipped with reverse polarity protection. It protects your Fridge/Freezer
against reverse battery connection and short circuit.
As a protection for your battery, the Fridge/Freezer switches OFF automatically if the power
source voltage is insufficient.
Emergency Override
If control panel malfunctions, emergency override function can be activated.
To activate emergency override, slide emergency switch to emergency override.
Temperature can not be set or adjusted when emergency override is activated.
Emergency mode is only to be used in the event of control panel malfunction.
Operating Instructions
The Temperature Controller provides the ability to set the desired temperature level and display
the current cabinet temperature.
The electronic controller has been programmed to maintain an average of the set temperature.
The compressor will start up when the internal cabinet temperature increases 0.5 to 1.5 degrees
above the set temperature and will run until the temperature is 0.5 to 1.5 degrees below the set
temperature.
When your Fridge/Freezer is first connected to the DC power input, press the power switch ON
and the digital read out will show the current cabinet temperature. To set your Fridge/Freezer to
the desired temperature, follow these steps:
Power On: Press and hold power button for 3 to 5 seconds until power button is red.
Temperature display will then illuminate and compressor will start and cooling will commence.
Adjust Temperature: Press the SET button once and the temperature display will flash-you can
then adjust the temperature level up or down with the up or down buttons.
Adjust Battery Setting: Press the SET button 2 times and the display will flash displaying the
current battery monitor setting you can then adjust the setting from Low/Medium/High by
pressing the up or down buttons. Press SET button again to confirm required setting.
